Avlink YX-3088 Manuel d'utilisateur télécharger pdf (Page 22)

YX Matrix Switching System—User Manual

7.0 Matrix Application Software

7.0.1 Software Introduction

The 《AV Matrix》 Matrix control software applies to different input/output matrixes.

7.0.1.1 Software Description

The《AV Matrix》 matrix testing software is an application tool developed for matrix testing

and application. The software operation environment is as follows:

Window98/2000/NT/XP operatng systems

32M interal memory or above

10M hard disk space or above

CD-ROM

At least one serial communicatin port

7.0.1.2 Software Activation

First, you must turn off power both to the YX matrix and to the computer. Then, connect the

matrix RS-232 port to the PC RS-232 port using the bundled communication cable. (Refer to the

previous section “YX Matrix and Control Computer Connection.”;

Turn on power to the YX matrix and the computer:

Activate the AV Matrix.exe on the bundled CD-ROM in the control computer to enter the

control software interface.

7.0.2 Software Features

The software controls signal connection between the corresponding input port and output port

as required. The main operation window is shown in Figure 7-1 below:

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 30 31

Pas de commentaire

Avlink YX-3088 Manuel d'utilisateur Page 22